FOR THE TOP SIDE (thinner rib):
Use pliers to position the ring into the join of 2 or 4 pieces. It should
go in until the wings are threaded into the pre-prepared holes. To remove,
twist with pliers.
Holding Rings are not necessary for new grass installations, since the roots will hold the system firmly in place.
FOR THE BOTTOM SIDE (rounded
rib): Put the ring over the join where 2 or 4 pieces cross, in such
a way that the wings are positioned above the Grill holes. Hand tighten
the wings so as to thread the rings into the holes. When it is in position,
you will hear a ‘click’. To remove, twist anticlockwise with pliers.
Example of how to assemble the
holding rings around the perimeter. The other rings are installed at each
intersection of 4 joining Garden Grids.
